file name

Discussion in 'Official REW (Room EQ Wizard) Support Forum' started by oliver, Jan 7, 2019.

  1. oliver

    oliver New Member
    Thread Starter

    Joined:
    May 24, 2017
    Messages:
    4
    Likes Received:
    0
    Location:
    Italy
    Hi John,

    Would be great to display the name of the mdat file that is loaded into REW somewhere, maybe in the main window, sometimes it's hard to remember the name of the file I am working on, so there is a risk of overwriting another one when saving.
    Do you have a plan to add it in the future?
    I am on OSX, do not know if on Windows the name is already displayed.

    Thank you,
    Best regards
     
  2. John Mulcahy

    John Mulcahy REW Author

    Joined:
    Apr 3, 2017
    Messages:
    1,129
    Likes Received:
    182
    The file name is shown on the measurement panel directly below the measurement name.
     
  3. oliver

    oliver New Member
    Thread Starter

    Joined:
    May 24, 2017
    Messages:
    4
    Likes Received:
    0
    Location:
    Italy
    Hi John,
    thanks to reply, but I cannot find it, the only place where I can see the name of the file is under "File", under the most recent files.
     
  4. John Mulcahy

    John Mulcahy REW Author

    Joined:
    Apr 3, 2017
    Messages:
    1,129
    Likes Received:
    182
    See below. Each measurement from a file shows the name of the file. There is no name until a measurement has been saved, of course.
    Screenshot 2019-01-07 at 20.54.04.jpg
     

Share This Page